2210 Troubleshooting Chart

 

 

TROUBLESHOOTING

The following chart shows some  activities an operator or maintenance person can easily accomplish.
Troubleshooting activities which go beyond the scope of those listed below are to be undertaken solely with input from
Kinematic Automation Service Personnel.

Description

Probable Cause

Main platen fails to hold card firmly when vacuum is turned on.

Additional vacuum slots beyond card footprint are turned On.
Card material not flat or debris between card and platen.
Vacuum slotting/slot is dirty or plugged.
Main air is turned Off.

Pivot platen fails to hold material during lamination.

Vacuum slots beyond footprint of material are On, causing leakage.
Platen vacuum slots are dirty or plugged.
Material is too porous for vacuum retention.
Main air is turned Off.
Pivot platen valve switch not On.

Tracks are not aligned in proper relationship to each other on card.

Incorrect track alignment key installed.
Incorrect material used in lamination sequence.
Incorrect track location selected during processing.

Main platen does not stay in desired position.

Track lock valve is toggled to Off position.
Air supply valve switch not On.

PREVENTIVE MAINTENANCE  - Assumes you have preformed this maintenance before and are familiar with this machine.

  • The Matrix 2210 Universal Card Laminator was designed and constructed to minimize maintenance requirements.

  • The preventive maintenance schedule for the Matrix 2210 Universal Card Laminator can be seen at a glance in the following tables. 

  • The scheduling is to be used solely as a guideline. 

  • Actual required maintenance frequencies depend heavily upon product parameters and use of the machine.

DAILY P.M.

MODULE

P.M. Task

PROCEDURE

Exterior Surfaces

Cleaning

1)     Wipe down top surfaces with a lint-free cloth, lightly dampened with denatured alcohol
(DO NOT SOAK PLATENS)

2)     Using a low-flow vacuum cleaner, vacuum all dust and debris from both platens

Air and vacuum Lines

Check Vacuum and Air Lines, clean and clear as required

1)     Remove bottom cover; verify that vacuum lines are free from debris. 

2)     Unplug and clear any lines containing foreign matter.

Vacuum Slots

Cleaning debris or adhesive from slots

Contact Kinematic - send machine to factory for cleaning

 

 

 

 

 

 

 

Other than this simple maintenance, no other periodic service is required.